matlab,signal-processing,phase

The FT is just a correlation of your signal with a cosine and sine wave, and the results give you phase and magnitude. Instead of doing a FT of the whole signal, just calculate the coefficient at your frequency of interest. As for the accuracy - the longer your signal,...

As explained on ehow.com Instructions: 1.) Measure the horizontal shift between two wave functions by graphing them. A shift to the right is a positive phase shift and a shift to the left is a negative phase shift. 2.) Determine the phase shift between the cosine function and the sine...

You can do it more simple: var clicker = document.getElementById("click"); clicker.onclick = do_this; function do_this (){ alert("this"); clicker.onclick = do_that; } function do_that (){ alert("that"); clicker.onclick = do_this; } http://jsfiddle.net/Ncz7w/...

matlab,signal-processing,phase

There are several ways that you can measure the phase shift between signals. Between your response, the comments below your response, and the other answers, you've gotten most of the options. The specific choice of technique is usually based on issues such as: Noisy or Clean: Is there noise in...

ssl,simulator,duration,traffic,phase

No, there is not. The netconvert application generates fixed phase cycles for all intersections by default. It always uses 31s as the green phase duration (changeable using option --tls.green-time) and 6s for left turn phases. The yellow time is computed based on the minimum deceleration and there isn't even an...